Delta C2000 also permits to create a small Text panel customized display with TPEditor, which we will follow at the end of the chapters.ĭownload the ISPsoft interal PLC programs and Drive parameters for VFDsoft.ĭVP12-SE PLC can be configured to exchange data between other PLCs via Ethernet(modbus TCP/IP) by using DCISoft Software. It can be also taken as an alternative for the analog input/output of the drive, when we need more than just 2 measurements. P2P is used when we want both motors to run at the same speed together in an application and monitor their current, its typical use can be applied to pumps, fans, conveyors, rollers. In this application note we are going to learn how to set up a Master – slave configuration, write, read and program the internal PLC with ISPsoft to work on a peer-to-peer (P2P) application with 2 motors, one used as a master and other as a slave. The Delta C2000 also uses MODBUS RTU as a built-in communication protocol. It has become the default protocol in many industry devices like PLCs, drives, sensors and it is highly used nowadays. MODBUS RTU uses RS-485 electrical standards and works on a Master-Slave setup, where a master writes and reads data into the registers of the slaves in the network. MODBUS RTU is a layer 2 network protocol created in the end of the 70’s with the necessity of a fieldbus protocol in industry to transmit and receive data in a simple way through the many devices of a network, in mind.
0 Comments
Leave a Reply. |